Multicharacter literal in C and C++

It makes it easier to pick out values in a memory dump.

Example:

enum state { waiting, running, stopped };

vs.

enum state { waiting = 'wait', running = 'run.', stopped = 'stop' };

a memory dump after the following statement:

s = stopped;

might look like:

00 00 00 02 . . . .

in the first case, vs:

73 74 6F 70 s t o p

using multicharacter literals. (of course whether it says 'stop' or 'pots' depends on byte ordering)

I don't know how extensively this is used, but "implementation-defined" is a big red-flag to me. As far as I know, this could mean that the implementation could choose to ignore your character designations and just assign normal incrementing values if it wanted. It may do something "nicer", but you can't rely on that behavior across compilers (or even compiler versions). At least "goto" has predictable (if undesirable) behavior...

That's my 2c, anyway.

Edit: on "implementation-defined":

From Bjarne Stroustrup's C++ Glossary:

implementation defined - an aspect of C++'s semantics that is defined for each implementation rather than specified in the standard for every implementation. An example is the size of an int (which must be at least 16 bits but can be longer). Avoid implementation defined behavior whenever possible. See also: undefined. TC++PL C.2.

also...

undefined - an aspect of C++'s semantics for which no reasonable behavior is required. An example is dereferencing a pointer with the value zero. Avoid undefined behavior. See also: implementation defined. TC++PL C.2.

I believe this means the comment is correct: it should at least compile, although anything beyond that is not specified. Note the advice in the definition, also.

Four character literals, I've seen and used. They map to 4 bytes = one 32 bit word. It's very useful for debugging purposes as said above. They can be used in a switch/case statement with ints, which is nice.

This (4 Chars) is pretty standard (ie supported by GCC and VC++ at least), although results (actual values compiled) may vary from one implementation to another.

But over 4 chars? I wouldn't use.

UPDATE: From the C4 page: "For our simple actions, we'll just provide an enumeration of some values, which is done in C4 by specifying four-character constants". So they are using 4 chars literals, as was my case.