How to redirect output to a file and stdout

The command you want is named tee:

foo | tee output.file

For example, if you only care about stdout:

ls -a | tee output.file

If you want to include stderr, do:

program [arguments...] 2>&1 | tee outfile

2>&1 redirects channel 2 (stderr/standard error) into channel 1 (stdout/standard output), such that both is written as stdout. It is also directed to the given output file as of the tee command.

Furthermore, if you want to append to the log file, use tee -a as:

program [arguments...] 2>&1 | tee -a outfile

$ program [arguments...] 2>&1 | tee outfile

2>&1 dumps the stderr and stdout streams.tee outfile takes the stream it gets and writes it to the screen and to the file "outfile".

This is probably what most people are looking for. The likely situation is some program or script is working hard for a long time and producing a lot of output. The user wants to check it periodically for progress, but also wants the output written to a file.

The problem (especially when mixing stdout and stderr streams) is that there is reliance on the streams being flushed by the program. If, for example, all the writes to stdout are not flushed, but all the writes to stderr are flushed, then they'll end up out of chronological order in the output file and on the screen.

It's also bad if the program only outputs 1 or 2 lines every few minutes to report progress. In such a case, if the output was not flushed by the program, the user wouldn't even see any output on the screen for hours, because none of it would get pushed through the pipe for hours.

Update: The program unbuffer, part of the expect package, will solve the buffering problem. This will cause stdout and stderr to write to the screen and file immediately and keep them in sync when being combined and redirected to tee. E.g.:

$ unbuffer program [arguments...] 2>&1 | tee outfile

Another way that works for me is,

<command> |& tee  <outputFile>

as shown in gnu bash manual

Example:

ls |& tee files.txt

If ‘|&’ is used, command1’s standard error, in addition to its standard output, is connected to command2’s standard input through the pipe; it is shorthand for 2>&1 |. This implicit redirection of the standard error to the standard output is performed after any redirections specified by the command.

For more information, refer redirection