Keep SSH session alive [closed]

The ssh daemon (sshd), which runs server-side, closes the connection from the server-side if the client goes silent (i.e., does not send information). To prevent connection loss, instruct the ssh client to send a sign-of-life signal to the server once in a while.

The configuration for this is in the file $HOME/.ssh/config, create the file if it does not exist (the config file must not be world-readable, so run chmod 600 ~/.ssh/config after creating the file). To send the signal every e.g. four minutes (240 seconds) to the remote host, put the following in that configuration file:

Host remotehost    HostName remotehost.com    ServerAliveInterval 240

To enable sending a keep-alive signal for all hosts, place the following contents in the configuration file:

Host *    ServerAliveInterval 240

I wanted a one-time solution:

ssh -o ServerAliveInterval=60 myname@myhost.com

Stored it in an alias:

alias sshprod='ssh -v -o ServerAliveInterval=60 myname@myhost.com'

Now can connect like this:

me@MyMachine:~$ sshprod

For those wondering, @edward-coast

If you want to set the keep alive for the server, add this to /etc/ssh/sshd_config:

ClientAliveInterval 60ClientAliveCountMax 2

ClientAliveInterval: Sets a timeout interval in seconds after which if no data has been received from the client, sshd(8) will send a message through the encrypted channel to request a response from the client.

ClientAliveCountMax: Sets the number of client alive messages (see below) which may be sent without sshd(8) receiving any messages back from the client. If this threshold is reached while client alive messages are being sent, sshd will disconnect the client, terminating the session.